Mestrado Profissional em Clínica Odontológica
URI Permanente desta comunidadehttps://repositorio.cesupa.br/handle/prefix/10
Navegar
Navegando Mestrado Profissional em Clínica Odontológica por Autor "Carneiro, Paula Mendes Acatauassú"
Agora exibindo 1 - 5 de 5
- Resultados por página
- Opções de Ordenação
Item Efeito anti-erosivo de géis experimentais a base de própolis sobre lesões iniciais em dentina cervical radicular bovina(Centro Universitário do Estado do Pará, 2024-09-24) Ribeiro, Breno Bevilaqua e Silva; Carneiro, Paula Mendes Acatauassú; http://lattes.cnpq.br/7375951134055063; Alencar, Cristiane de Melo; http://lattes.cnpq.br/4783175034033264; Araújo, Jesuina Lamartine Nogueira; http://lattes.cnpq.br/4860837494466416; Oliveira, Roberta Pimentel de; http://lattes.cnpq.br/6689993037436832Objective: The aim of this study was to evaluate the preventive potential of na experimental propolis-based gels on the inorganic structure of initial dentin erosion lesions. Materials and Methods: Forty bovine cervical dentin samples (4x4x2 mm) were obtained and pre-eroded in a 1% citric acid solution, pH 2.0, for 10 minutes. The samples were then randomized into four groups based on the anti-erosive treatment: G1 – experimental gel without active component; G2 – experimental gel with 0.5% propolis; G3 – experimental gel with 1% propolis; G4 – Ultra EZ desensitizing gel (Ultradent, Indaiatuba, SP, Brazil). Erosion cycling and treatment were performed for 3 days. After cycling, the samples were subjected to 3D profilometry testing to map the surface topography and measure the tooth structure loss (TSL). Scanning electron microscopy (SEM) was then performed for qualitative analysis to assess the surface morphology of the specimens. The One-way ANOVA test, followed by the Tukey post-test, was used to analyze the data. Results: The lowest roughness values were observed in the experimental group G3 (p < 0.05). Additionally, TSL was significantly lower in group G3 compared to the other groups (p < 0.05). The experimental groups G2 and G3 showed obliteration of dentinal tubules. Furthermore, in G3, a high coverage of precipitates on the surface of the samples was observed. Conclusion: Thus, the experimental propolis-based gel at 1% showed promising performance on initial dentin erosion lesions.Item Impacto da manipulação de resinas compostas com luvas de procedimento sobre suas propriedades mecânicas: uma revisão sistemática(Centro Universitário do Estado do Pará, 2024-09-27) Manzoli, Lorâine Perez; Alencar, Cristiane de Melo; Takeuchi, Elma Vieira; http://lattes.cnpq.br/0868780137414166; http://lattes.cnpq.br/4783175034033264; Carneiro, Paula Mendes Acatauassú; http://lattes.cnpq.br/7375951134055063; Silva, Aryvelto Miranda; http://lattes.cnpq.br/0419320072195966Objectives: To perform a systematic review to evaluate the impact of handling composite resin with a procedure glove on the mechanical characteristics of direct restorations. Materials and methods: The PRISMA guidelines for systematic reviews were followed. Experimental studies that evaluated the effect of glove-based composite resin manipulation on the mechanical characteristics of direct restorations were selected. The literature search was performed on September 11, 2024, in the following databases: MEDLINE via PubMed, SCOPUS, Cochrane Library, VHL Regional Portal, and Open Grey Literature. To analyze the risk of bias, this study followed a scoring system adapted from systematic reviews focusing on in vitro studies. Materials and methods: A total of 105 studies were found (94 were removed after removing duplicates and reading the title and abstract). Only 8 articles were selected for qualitative analysis, of which 1 was excluded because it met one or more exclusion criteria. Through a manual search, 2 more studies were included, resulting in 10 articles evaluated at the end of this systematic review. No meta-analysis was performed in this systematic review due to the high heterogeneity between the studies, greater than 50% (I2 = 86%). Conclusion: Most studies have shown that handling composite resins with procedure gloves can cause damage to mechanical characteristics related to surface microhardness, roughness, shear bond, bond strength, compressive strength and adhesive strength of direct restorations. However, cleaning with 70% alcohol appears to partially reverse this process. On the other hand, future research is needed to demonstrate the limited confidence in the estimated effects in this investigation.Item Influência do tipo de escova e da força de escovação no desgaste dental erosivo(Centro Universitário do Estado do Pará, 2019) Souza, Cíntia de Melo Silva; Esteves, Renata Antunes; Carneiro, Paula Mendes Acatauassú; http://lattes.cnpq.br/7375951134055063; http://lattes.cnpq.br/0001642348652061; Loretto, Sandro Cordeiro; http://lattes.cnpq.br/6988325260181483; Alves, Eliane Bemerguy; http://lattes.cnpq.br/3442162475756349The objective of this study was to evaluate, in vitro, the influence of manual toothbrushes with different characteristics and two brushing load on microhardness and surface loss of bovine enamel after erosive and abrasive cycling. Specimens of bovine enamel (n = 10) were made in 3x3mm dimensions, where initial erosive lesions were made by citric acid cycling and randomly distributed in 10 experimental groups: A1- Colgate Slim Soft with 1.5N load; A2- Colgate Slim Soft with 3N load; B1- Curaprox 5460 with 1.5 N load; B2- Curaprox 5460 with 3N of load; C1- Oral B Indicator with 1.5N load; C2- Oral B Indicator with 3N load; D1- Johnson & Johnson Professional with 1.5N load; D2- Johnson & Johnson Professional with 3N load; E1- Sensodyne Repair & Protect with 1.5N load; E2- Sensodyne Repair & Protect with 3N load. Microhardness evaluation was performed after abrasive challenge. Surface loss was assessed by non-contact optical profilometry after 5 days erosive and abrasive cycling. Results were evaluated by analysis of variance (ANOVA) and Tukey test, with a significance level of 5%. It was concluded that the microhardness was influenced by the load, where the higher load showed increased hardness when removing the softened enamel layer.? Surface loss was influenced by brush characteristics and load, and soft brushes promoted less surface loss.Item Influência erosiva do tucupi na resistência da união ao esmalte e dentina(Centro Universitário do Estado do Pará, 2020-12-16) Carneiro, Reginna Vyctoria da Trindade Souza de Melo; Loretto, Sandro Cordeiro; Ribeiro, Mara Eliane Soares; http://lattes.cnpq.br/5959446285132739; http://lattes.cnpq.br/6988325260181483; Carneiro, Paula Mendes Acatauassú; http://lattes.cnpq.br/7375951134055063; Souza Junior, Mário Honorato Silva e; http://lattes.cnpq.br/9220706169410814The present study evaluated the erosive influence of tucupi on the resistance of the adhesive bond to enamel and dentin. 168 healthy bovine incisors teeth were used, divided into 12 groups (n = 14). For erosive cycling, distilled water (negative control), cola-based soft drink (positive control) and tucupi were used. The adhesive strategies used were: (1) total acid conditioning (conventional) and (2) self-conditioning. All specimens were subjected to cycling with the drinks described above for 5 days and, after 24h of the 5th day, composite resin cylinders were made for the micro shear resistance test. The data showed normal distribution and were analyzed by two-way ANOVA, followed by the Tukey post-test (p≤0.05). There were no significant differences in enamel (p>0.05). In dentin, only the groups exposed to cola-based soft drink showed significant differences (p<0.01). The erosive challenge with tucupi did not influence the bond strength to enamel and dentin, independent of the adhesive strategy used.Item Influência erosiva do tucupi na resistência de união de interfaces adesivas preestabelecidas em esmalte e dentina(Centro Universitário do Estado do Pará, 2022-06-01) Wanderley, Marina Lima; Loretto, Sandro Cordeiro; Ribeiro, Mara Eliane Soares; http://lattes.cnpq.br/5959446285132739; http://lattes.cnpq.br/6988325260181483; Carneiro, Paula Mendes Acatauassú; http://lattes.cnpq.br/7375951134055063; Gatti, Joyce Figueira de Araújo; http://lattes.cnpq.br/0188270217176622This study evaluated the erosive influence of tucupi on the bond strength of pre-established adhesive interfaces to enamel and dentin. A total of 168 healthy bovine incisors were used, divided into 12 groups (n=14) according to the type of substrate (enamel or dentin), type of erosive cycling (distilled water, cola soft drink or tucupi), and type of adhesive strategy used (Etch&rinse and self-etch). The groups were: G1: enamel (ESM)+distilled water (H2O)+ Etch&rinse (ER); G2: dentin (DEN)+H2O+ER; G3:ESM+ cola soft drink (RBC) + ER; G4: DEN+RBC+ER; G5: ESM+tucupi (TUC)+ER; G6: DEN + TUC + ER; G7: ESM + H2O + self-etch (SE); G8: DEN + H2O + SE; G9: ESM + RBC + SE; G10: DEN +RBC+ SE; G11: ESM+TUC+SE; G12: DEN+TUC+SE. Cylinders of resin were made on enamel or dentin surfaces and, after 24 hours, the specimens were submitted to erosive cycling for 5 days. After 24 hours of the last cycle, a microshear test was performed. Analysis of fracture was performed using a stereoscopic magnifying glass. The results were submitted to two-way ANOVA, followed by Tukey's post-test, with results described as mean and standard deviation (α=5%). The groups exposed to tucupi showed significantly lower bond strength (p<0.05) in relation to the negative control groups (distilled water), and were statistically similar to the positive control groups (cola soft drink), both in enamel and dentin, for both adhesive strategies used. Therefore, it was possible to conclude that erosive cycling with tucupi influenced the bond strength of pre-established adhesive interfaces in enamel and dentin, regardless of the adhesive strategy.